This is the 3U version of the low cost cases A-100LC6/LC9. The A-100LC3 is very similar to the A-100LC6 but offers one row with 84 HP for installation of modules instead of two. A-100LC3 is equipped with one power supply (1200mA) and one bus board. To maximise the internal space the power supply of the DIY-Kit #1 with an external transformer is used (same as for the DIY-Kit #1: 15V AC/2500mA). At the left side of the case the connector for the external transformer is located. The external transformer is not shown in the pictures.
outside: approx. 445 (width) x 160 (depth) x 150 (height)
inside: 1 x 84 HP x 3 U (one bus board), useable depth for A-100 modules: approx. 110 mm (measured from inner side of the front panel until end of the pc board of the module)
Quantity of bus boards: 1
Weight (without modules): about 2.5 kg without external transformer, about 3.5 kg with external transformer
mains voltage: 115V~ or 230V~ (please specify when you order because of the correct voltage fo the external power supply)
output voltages/current: +12V/1200mA, -12V/1200mA, in contrast to the other A-100 cases the A-100 LC3 has no +5V available ! If required the 5V adapter A-100AD5 can be used.
technical data of the external power supply: 15V AC / 2500 mA output, low voltage connector 5.5/2.1 mm outer/inner diameter, the supply is included with the A-100LC3