We say...
A pre-owned Plankton Electronics Jellyfish V2 in very good condition. It comes with a eurorack power cable
Manufacturer's description
Based on the original The Jellyfish, The Jellyfish V2 Modular is a PT2399 based delay in eurorack format. It includes an input pot with saturation red led, a mix section, a LFO with an external output, Time, Fine and Feedback controls with infinite feedback, a sync input! and lots of modulation possibilities.
CONTROLS
- IN: attenuator for the incoming signal. The associated red led will start to glow just a few mV before the signal is clipping inside the delay IC. Note that when extreme feedback is used the led will glow independently of the incoming signal.
- WET & DRY: mix pots for the signals. WET control the amount of delay sent to the output while DRY sends the input signal directly to the out.
- TIME & FINE: delay time pots. The main control of the module. Turn it to get delay times from 27 to 570 mseg. NOTE: When powering up the machine these controls can not be in it’s lower position or the IC will not work. Turn it up a little bit before.
- FDBCK: feedback control. This is the amount of delayed signal that is send again inside the delay. It goes from 1 repetition to infinite.
- RATE: The frequency of the LFO.
- DEPTH: The amount of LFO signal that is sent to the time parameter of the delay. Very useful for create vibrato effects or other crazy deep sea sounds. -WAVE: choose between a square or triangle wave for the LFO. -CV TIME: attenuator for the incoming CVT signal.
- CV FDBCK: attenuator for the incoming CVF signal.
- CV WET: attenuator for the incoming CVW signal.
CONNECTORS
- IN & OUT: input and output audio signals for the module. DC coupled.
- SEND & RETURN: path between the feedback section. When a jack is plugged the delay signal is cut. Use for connect other effects here and transform the delayed signal. Connect another Jellyfish here crossing it’s send and returnconnections to create the Xdelay function from the desktop one. Connect a chain of effects. Or just connect a pair of diodes pointing to ground to saturate and smooth the delayed sound.
- LFO: output of the LFO as its full amplitude. It not responds to the depth knob.
- SYNC: insert a clock signal here and delay will clock to it. 256 steps. Any square wave between 0 and 5V will do the job. Note that the wave length of the clock signal must be inside the delay parameters. If note it will clock to its max or min position. Experiment with different signals. Signals higher to 5V or lower than 0 will not affect the delay.
- CVT, CVF & CVW: modulation inputs that will add to the Time, Feedback and Wet controls. The real power for the modular version. Experiment with it as much as you can!
SPECS:-
- width: 17HP eurorack format.
- power: +12v / -12V power supply. (5V internal regulator) 61mA@12V, 54mA@-12V
How much is my shipping?
Shipping is automatically calculated before you submit your payment information. Simply add items to your cart and proceed to the checkout page, where you'll be offered shipping options and their prices. In the UK, 'next working day' shipping is free if the order value is over £150, and £5 otherwise. We can also ship on a 'next working day before 12pm' service, which costs £6 for orders over £150 and £7.50 for orders under £150.
Do you ship to my country?
Almost certainly - the site will give you an estimate of shipping costs if you add an item to the cart and then enter your country and postcode. If you have specific requirements (such as if you prefer UPS over FedEx, for example) then let us know in advance and we'll try to work something out for you.
Shipping methods
We use a combination of DPD and Royal Mail for the UK, and for international orders it's either DPD, DHL, FedEx, UPS or Royal Mail depending on where you are in the world. If you have a particular preference then try to let us know BEFORE you order so we can look into it for you. Please note that there may occasionally be additional shipping charges if you live in a remote area, depending on what surcharges are applied by the shipper. We'll get in touch to discuss this with you in such cases.
Dispatch times
For UK orders, we normally dispatch the same working day if we get the order before 16:00. If you have a really urgent situation then of course drop us an email before ordering and we'll always do our absolute best to accommodate you.
For international orders, we normally dispatch the same day if we get the order before 13:00 but again, occasionally it might be the next day before we can send it out, and sometimes the couriers may come to collect a little earlier than scheduled which would also push an order into the next day.
Saturday/Sunday delivery
If you're in the UK and you order before 16:00 on a Friday then we can send something for a Saturday or Sunday delivery with DPD. This is FREE for order values over £350, £5 for order values between £75 and £250, and £7 for order values under £75. (NB: this applies to UK mainland addresses only). Please note that any orders placed after 16:00 on a Friday will ship on the Monday.
International shipping times
Most orders are delivered within 3 to 5 working days if sent on a courier service. Royal Mail services can take a lot longer and are often less secure.
Pre-orders
If a product is listed as a pre-order, it means we've ordered it from the supplier but it's not physically in stock yet. The product listing will include an estimated shipping date based on the best information we have from the supplier, but do bear in mind this is subject to change and is not a guaranteed date.
If you place an order containing a mixture of in-stock and pre-order items, we'll normally hold off on shipping anything until the pre-order item(s) have arrived, rather than splitting it into multiple shipments. If you need the in-stock items sooner, we'd recommend placing separate orders. As always, please get in touch if you have questions.
Product Overview
We say...
A pre-owned Plankton Electronics Jellyfish V2 in very good condition. It comes with a eurorack power cable
Manufacturer's description
Based on the original The Jellyfish, The Jellyfish V2 Modular is a PT2399 based delay in eurorack format. It includes an input pot with saturation red led, a mix section, a LFO with an external output, Time, Fine and Feedback controls with infinite feedback, a sync input! and lots of modulation possibilities.
CONTROLS
- IN: attenuator for the incoming signal. The associated red led will start to glow just a few mV before the signal is clipping inside the delay IC. Note that when extreme feedback is used the led will glow independently of the incoming signal.
- WET & DRY: mix pots for the signals. WET control the amount of delay sent to the output while DRY sends the input signal directly to the out.
- TIME & FINE: delay time pots. The main control of the module. Turn it to get delay times from 27 to 570 mseg. NOTE: When powering up the machine these controls can not be in it’s lower position or the IC will not work. Turn it up a little bit before.
- FDBCK: feedback control. This is the amount of delayed signal that is send again inside the delay. It goes from 1 repetition to infinite.
- RATE: The frequency of the LFO.
- DEPTH: The amount of LFO signal that is sent to the time parameter of the delay. Very useful for create vibrato effects or other crazy deep sea sounds. -WAVE: choose between a square or triangle wave for the LFO. -CV TIME: attenuator for the incoming CVT signal.
- CV FDBCK: attenuator for the incoming CVF signal.
- CV WET: attenuator for the incoming CVW signal.
CONNECTORS
- IN & OUT: input and output audio signals for the module. DC coupled.
- SEND & RETURN: path between the feedback section. When a jack is plugged the delay signal is cut. Use for connect other effects here and transform the delayed signal. Connect another Jellyfish here crossing it’s send and returnconnections to create the Xdelay function from the desktop one. Connect a chain of effects. Or just connect a pair of diodes pointing to ground to saturate and smooth the delayed sound.
- LFO: output of the LFO as its full amplitude. It not responds to the depth knob.
- SYNC: insert a clock signal here and delay will clock to it. 256 steps. Any square wave between 0 and 5V will do the job. Note that the wave length of the clock signal must be inside the delay parameters. If note it will clock to its max or min position. Experiment with different signals. Signals higher to 5V or lower than 0 will not affect the delay.
- CVT, CVF & CVW: modulation inputs that will add to the Time, Feedback and Wet controls. The real power for the modular version. Experiment with it as much as you can!
SPECS:-
- width: 17HP eurorack format.
- power: +12v / -12V power supply. (5V internal regulator) 61mA@12V, 54mA@-12V
Technical Specs
Shipping Details
How much is my shipping?
Shipping is automatically calculated before you submit your payment information. Simply add items to your cart and proceed to the checkout page, where you'll be offered shipping options and their prices. In the UK, 'next working day' shipping is free if the order value is over £150, and £5 otherwise. We can also ship on a 'next working day before 12pm' service, which costs £6 for orders over £150 and £7.50 for orders under £150.
Do you ship to my country?
Almost certainly - the site will give you an estimate of shipping costs if you add an item to the cart and then enter your country and postcode. If you have specific requirements (such as if you prefer UPS over FedEx, for example) then let us know in advance and we'll try to work something out for you.
Shipping methods
We use a combination of DPD and Royal Mail for the UK, and for international orders it's either DPD, DHL, FedEx, UPS or Royal Mail depending on where you are in the world. If you have a particular preference then try to let us know BEFORE you order so we can look into it for you. Please note that there may occasionally be additional shipping charges if you live in a remote area, depending on what surcharges are applied by the shipper. We'll get in touch to discuss this with you in such cases.
Dispatch times
For UK orders, we normally dispatch the same working day if we get the order before 16:00. If you have a really urgent situation then of course drop us an email before ordering and we'll always do our absolute best to accommodate you.
For international orders, we normally dispatch the same day if we get the order before 13:00 but again, occasionally it might be the next day before we can send it out, and sometimes the couriers may come to collect a little earlier than scheduled which would also push an order into the next day.
Saturday/Sunday delivery
If you're in the UK and you order before 16:00 on a Friday then we can send something for a Saturday or Sunday delivery with DPD. This is FREE for order values over £350, £5 for order values between £75 and £250, and £7 for order values under £75. (NB: this applies to UK mainland addresses only). Please note that any orders placed after 16:00 on a Friday will ship on the Monday.
International shipping times
Most orders are delivered within 3 to 5 working days if sent on a courier service. Royal Mail services can take a lot longer and are often less secure.
Pre-orders
If a product is listed as a pre-order, it means we've ordered it from the supplier but it's not physically in stock yet. The product listing will include an estimated shipping date based on the best information we have from the supplier, but do bear in mind this is subject to change and is not a guaranteed date.
If you place an order containing a mixture of in-stock and pre-order items, we'll normally hold off on shipping anything until the pre-order item(s) have arrived, rather than splitting it into multiple shipments. If you need the in-stock items sooner, we'd recommend placing separate orders. As always, please get in touch if you have questions.
