Rode NT1 Kit w/ SM6 Shock Mount, Pop Shield & Mic Cable (B-Stock)

£188.00
In stock
SKU
NT1KIT-B

Unit in superb condition, box slightly worn

Unit in superb condition, box slightly worn

The detailed midrange response, coupled with the silky smooth high frequencies and the warm, round bass reproduction make the NT1 an absolute standout in its class.

The transducer is suspended inside the microphone using an SM6 shockmount which minimises external vibrations at the capsule level. The high-grade electronics have been designed to provide the lowest noise level possible, the Rode NT1 measures only 4.5dBa of self-noise.

Completely redesigning the NT1-A from the ground up, the only aspect that Rode have kept is the metal grille. Corrosion-resistant and covered in a military-grade, scratch-resistant coating, each NT1 is tested meticulously to give you the best experience possible.

Features / Specifications
Includes SM6 shockmount and XLR lead
Large capsule with gold-plated membrane
Cardioid polar pattern
Ultra-low noise transformerless circuitry
State-of-the-art surface mount electronics
Heavy-duty matte black finish
Acoustic Principle: Presure Gradient
Active electronics: JFET impedance converter with bipolar output buffer
Directional Pattern: Cardioid
Frequency Range: 20 Hz - 20 kHz
Output Impedance: 100 Ohm
Equivalent Noise: 4.5 dBA SPL (as per IEC651)
Maximum Output: 8.0mV (1kHz, 1 THD into 1K ohm load)
Sensitivity: -29 dB re 1V/Pa (35 mV @ 94dB SPL) +/- 2dB @ 1kHz
Dynamic Range: 128dB SPL
Maximum SPL: 132 dB SPL
Signal/Noise: 90 dBa SPL (as per IEC651)
Power Requirements: 24V phantom power
Output connection: 3 Pin XLR, Balanced output between pin 2 (+), pin 3 (-) and pin 1 (ground)
Weight: 395g
Includes: Shockmount, Pop Shield, XLR cable

Features / Specifications
Includes SM6 shockmount and XLR lead
Large capsule with gold-plated membrane
Cardioid polar pattern
Ultra-low noise transformerless circuitry
State-of-the-art surface mount electronics
Heavy-duty matte black finish
Acoustic Principle: Presure Gradient
Active electronics: JFET impedance converter with bipolar output buffer
Directional Pattern: Cardioid
Frequency Range: 20 Hz - 20 kHz
Output Impedance: 100 Ohm
Equivalent Noise: 4.5 dBA SPL (as per IEC651)
Maximum Output: 8.0mV (1kHz, 1 THD into 1K ohm load)
Sensitivity: -29 dB re 1V/Pa (35 mV @ 94dB SPL) +/- 2dB @ 1kHz
Dynamic Range: 128dB SPL
Maximum SPL: 132 dB SPL
Signal/Noise: 90 dBa SPL (as per IEC651)
Power Requirements: 24V phantom power
Output connection: 3 Pin XLR, Balanced output between pin 2 (+), pin 3 (-) and pin 1 (ground)
Weight: 395g
Includes: Shockmount, Pop Shield, XLR cable

Copyright © 2021 www.signalsounds.com. All Rights Reserved.